| Teil no | Hersteller | Application |
|---|
| MAX800LEPE | MAXIMIC | Microprocessor supervisory circuit. Reset threshold(typ) 4.65V. Guaranteed power-fail accuracy to +-2% |
| MAX165AEWN | MAXIMIC | CMOS microprocessor-compatible, 5 microsec, 8-bit ADC. Error +-1/2 LSB. Plug-in upgrade to the MX7575. |
| MAX6318MHUK32CX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.200V, reset timeout(min) 140ms, watchdog timeout(typ) 102ms |
| MAX4326EUA | MAXIMIC | Dual, low-cost, low-power, Rail-to-Rail I/O op amp. BW 5MHz. |
| MAX251EJD | MAXIMIC | +5V powered isolated RS-232 driver/receiver. |
| MAX6319MHUK43B-T | MAXIMIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.300V, reset timeout(min) 20ms |
| MAX4527CSA | MAXIMIC | Phase-reversal analog switch. |
| MAX4553CEE | MAXIMIC | +-15kV ESD-protected, quad, low-voltage, SPST analog switches (two NO and two NC switches). |
| MAX192BCAP | MAXIMIC | Low-power, 8-channel, serial 10-bit ADC. Error(LSB) +-1. |
| MAX4664CSE | MAXIMIC | 5om, quad, SPST, CMOS analog switch (four NC switches). |
| MAX6316LUK35BY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.500V, min reset timeout 20ms, typ watchdog timeout 1.6sec |
| MAX801LESA | MAXIMIC | Supervisory circuit with +-1.5% reset accuracy. Reset threshold(typ) 4.675V. Watchdog. |
| MAX4599EUT-T | MAXIMIC | Low-voltage, single-supply +2V to 5.5V operation, SPDT analog switch. |
| MAX4567CSE | MAXIMIC | Dual SPDT switches, low-voltage, bidirectional RF/video switch. |
| MAX4275BEESA | MAXIMIC | Dual, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 24, 1+ (Rf/Dg) noninverting gain 25, -3dB BW 590kHz. |
| MAX6316LUK30DZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.000V, min reset timeout 1.12sec, typ watchdog timeout 25.6sec |
| MAX635AESA | MAXIMIC | Preset -5V output or adjuistable output with 2 resistors, CMOS switching regulator. Output accuracy 5%. |
| MAX872CPA | MAXIMIC | 10microA, low-dropout, precision voltage reference. Output voltage 2.500V +-0.2%. Wide operating voltage range 2.7V to 20V. Line regulation over temp. 20microV/V. Load regulation over temp. 0.6mV/mA max |
| MAX6309UK32D4-T | MAXIMIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,manual-reset input).Factory-trimmed reset thresholds 3.120(min),3.280(max) Nominal timeout period 1120ms. |
| MAX6320PUK33BZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.300V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX810ZEUR-T10 | MAXIMIC | Microprocessor reset circuit. Reset threshold 2.32V. Push-pull active-high reset. 10k increments. |
| MAX5351BCUA | MAXIMIC | Low-power, 13-bit voltage-output DAC with serial interface. INL (LSB) +-2. +3.3V single-supply operation. |
| MAX5151AEEE | MAXIMIC | Low-power, dual, 13-bit voltage-output DAC with serial interface. +3V single-supply operation. INL(LSB) +-1. |
| MAX6321HPUK29AZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.930V, reset timeout(min) 1ms, watchdog timeout(typ) 25.6sec |
| MAX6319LHUK47C-T | MAXIMIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 4.700V, reset timeout(min) 140ms |
| MAX4664ESE | MAXIMIC | 5om, quad, SPST, CMOS analog switch (four NC switches). |
| MAX5153BEPE | MAXIMIC | Low-power, dual, 13-bit voltage-output DAC with configurable output amplifier. +3V single-supply operation. INL(LSB) +-2. |
| MAX4255EUK-T | MAXIMIC | Single, single-supply operation +2.4V to 5.5V, low-noise, low-distortion, Rail-to-Rail op amp. Gain bandwidth 22MHz, min stable gain 10V/V. |
| MAX5150BMJE | MAXIMIC | Low-power, dual, 13-bit voltage-output DAC with serial interface. +5V single-supply operation. INL(LSB) +-1. |
| MAX536BCWE | MAXIMIC | Calibrated, quad, 12-bit voltage-output DAC with serial interface. +-1LSB total unadijusted error. INL (LSB) +-1 |
