| Teil no | Hersteller | Application |
|---|
| MAX6380UR38-T | MAXIMIC | Ultra-low-power voltage detector, 3.8V |
| MAX6318LHUK44DW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 4.390V min, reset timeout 1.12sec,typ watchdog timeout 6.3ms |
| MAX4258ESA | MAXIMIC | 250MHz -3bB bandwidth, 2-channel video multiplexer-amplifier. |
| MAX620C/D | MAXIMIC | Quad, high-side MOSFET driver |
| MAX4617CSE | MAXIMIC | Low-woltage, high-speed, CMOS analog IC configured as 8-channel multiplexer |
| MAX6346UR34-T | MAXIMIC | Microprocessor supervisory circuit (reset output active-low, push-pull). Reset threshold (typ) 3.400V. Order increment 10k |
| MAX1698EUB | MAXIMIC | High-efficiency step-up current regulator for LEDs. |
| MAX4270EEE | MAXIMIC | Dual, ultra-low-distortion, single-supply, 200MHz op apm with enable. Min gain 5V/V, single-supply operation +4.5V to +8.0V |
| MAX4128EUA | MAXIMIC | Dual, wide-bandwidth, low-power, single-supply Rail-to-Rail I/O op amp. BW 25MHz. |
| MAX319C/D | MAXIMIC | Precision, CMOS analog switch |
| MAX325EJA | MAXIMIC | Precision, single-supply, SPST analog switch. |
| MAX221EEUE | MAXIMIC | +-15kV ECD-protected, +5V, 1microA, single RS-232 transceiver with AutoShutdown. |
| MAX4613ESE | MAXIMIC | Quad, SPST, CMOS analog switch has two NC and two NO switches. |
| MAX903EPA | MAXIMIC | High-speed, low-power voltage comparator |
| HI3-0201-9 | MAXIMIC | Quad SPST CMOS analog switch |
| MAX506ACPP | MAXIMIC | Quad 8-bit DAC with Rail-to-Rail voltage outputs. Separate input latches for each of its four DACs. TUE +-1 LSB. |
| MAX6314US38D2-T | MAXIMIC | 68H11/bidirectional-compatible microprocessor reset circuit. Reset threshold(nom) 3.80V. Reset timeout period(min) 20ms. |
| MAX188DEWP | MAXIMIC | Low-power, 8-channel, serial 12-bit ADC. |
| MAX6306UK50D3-T | MAXIMIC | Multiple-input, programmable reset IC (open-drain reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual reset input). Factory-trimmed reset thresholds 4.875(min),5.125(max) Nominal timeout period 140ms. |
| MAX631AESA | MAXIMIC | CMOS fixed +5V output voltage,adjustable output with 2 resistors step-up switching regulator. 5% output accuracy. |
| MAX6378UR42-T | MAXIMIC | Ultra-low-power voltage detector, 4.2V |
| MAX182AEWI | MAXIMIC | Calibrated 4-channel 12-bit ADC with T/H and reference. |
| MAX6320PUK25AY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 2.500V, reset timeout(min) 1ms, watchdog timeout(typ) 1.6sec |
| MAX6316LUK49AZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reser input,reser output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.900V, min reset timeout 1ms, typ watchdog timeout 25.6sec |
| MAX706TESA | MAXIMIC | Low-cost, microprocessor supervisory circuit. Precison supply-voltage monitor 3.08V. Active-low reset output signal. |
| MAX6320PUK25AZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 2.500V, reset timeout(min) 1ms, watchdog timeout(typ) 25.6sec |
| MAX6317HUK49AW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.900V, min reset timeout 1ms, typ watchdog timeout 6.3ms |
| MAX249EQH | MAXIMIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MXD1000C/D250 | MAXIMIC | 5-tap silicon delay line |
| MAX6318LHUK43BW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 4.300V min, reset timeout 20ms,typ watchdog timeout 6.3ms |
