| Teil no | Hersteller | Application |
|---|
| MAX4523ESE | MAXIMIC | Quad, low-voltage, SPST analog switch. |
| MAX6314US30D4-T | MAXIMIC | 68H11/bidirectional-compatible microprocessor reset circuit. Reset threshold(nom) 3.00V. Reset timeout period(min) 1120ms. |
| MAX323MJA | MAXIMIC | Precision, single-supply, SPST analog switch. |
| MAX6320PUK45CX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.500V, reset timeout(min) 140ms, watchdog timeout(typ) 102ms |
| MAX456CPL | MAXIMIC | 8 x 8 video crosspoint switch. |
| MAX9002ESA | MAXIMIC | Low-power, high-speed, single-supply op amp + comparator. Op-Amp gain stability 1V/V. Op-Amp gain bandwidth 1.25MHz. |
| MAX490EEPA | MAXIMIC | +-15kV ESD-protected, low-power, RS-485/RS-422 transceiver. Full-duplex. Data rate 2.5Mbps. Slew-rate limited - n0. Low-power shutdown - no. Receiver/driver enable - no. Quiescent current - 300 microA. Number of transmitter on bus - 32. |
| MAX427CSA | MAXIMIC | Low noise, high-precision op amp. |
| MAX867ESA | MAXIMIC | 5V or adjustable-output, single-cell DC-DC converter |
| MAX4613EUE | MAXIMIC | Quad, SPST, CMOS analog switch has two NC and two NO switches. |
| MAX3223EEAP | MAXIMIC | +-15kV ESD-protected, 1microA, 3.0 to 5.5V, 250kbps, RS-232 transceiver with AutoShutdown. |
| MAX6316MUK27BW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 2.700V, min reset timeout 20ms, typ watchdog timeout 6.3ms |
| ICL7109MJL | MAXIMIC | 12 bit A/D converter with 3-state binary outputs |
| MAX6319LHUK35A-T | MAXIMIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 3.500V, reset timeout(min) 1ms |
| MAX6318LHUK48BY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input, reset output active-low, push/pull; active-high,push/pull).Factory-trimmed reset threshold (typ) 4.800V, min reset timeout 20ms, typ watchdog timeout 1.6sec |
| MAX972CUA | MAXIMIC | Ultra-low-power, open-drain, dual comparator. Internal precision reference none. Internal hysteresis no. |
| MAX4522MJE | MAXIMIC | Quad, low-voltage, SPST analog switch. |
| MAX6317HUK26CY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 2.630V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX879CSA | MAXIMIC | Step-up/step-down DC-DC converters |
| MAX6319MHUK27B-T | MAXIMIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 2.700V, reset timeout(min) 20ms |
| ICL7612AMTV | MAXIMIC | Single operational amplifier, 2mV |
| MAX197ACAI | MAXIMIC | Multi-range (+10V, +5V, +10V, +5V), single +5V, 12-bit DAS with 8+4 bus interface |
| MAX4402ASA | MAXIMIC | Dual, low-cost, single-supply +2.5V to 5.5V, Rail-to-Rail op amp. |
| MAX6380UR45-T | MAXIMIC | Ultra-low-power voltage detector, 4.5V |
| MAX537ACPE | MAXIMIC | Calibrated, quad, 12-bit voltage-output DAC with serial interface. +-5V supply operation. INL (LSB) +-1/2 |
| MAX1645AEEI | MAXIMIC | Advanced chemistry-independent, level 2 battery chargers with input current limiting |
| MAX770CPA | MAXIMIC | 5V or adjustable, high-efficiency, low IQ, step-up DC-DC controller |
| MAX6318MHUK34AY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.400V, reset timeout(min) 1ms, watchdog timeout(typ) 1.6sec |
| MAX792RMJE | MAXIMIC | Microprocessor and non-volatile metory supervisory circuit. Reset threshold 2.61V |
| MAX971ESA | MAXIMIC | Ultra-low-power, open-drain, single comparator. Internal precision reference 1%. Internal hysteresis yes. |
