| Teil no | Hersteller | Application |
|---|
| MAX3222ECWN | MAXIMIC | +-15kV ESD-protected, down to 10nA, 3.0V to5.5V, up to 1Mbps, true RS-232 transceiver. |
| MAX318C/D | MAXIMIC | Precision, CMOS analog switch |
| MAX6317HUK49AX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.900V, min reset timeout 1ms, typ watchdog timeout 102ms |
| MAX6317HUK25AW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 2.500V, min reset timeout 1ms, typ watchdog timeout 6.3ms |
| MAX698CPA | MAXIMIC | Low cost power-on reset controller. |
| DG387AK | MAXIMIC | General purpose CMOS quad analog switch. |
| MAX6315US34D1-T | MAXIMIC | Open-drain microprocessor reset circuit. Reset threshold(nom) 3.40V. Reset timeout period(min) 1ms. |
| MAX6309UK40D3-T | MAXIMIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,manual-reset input).Factory-trimmed reset thresholds 3.900(min),4.100(max) Nominal timeout period 140ms. |
| MAX809TEUR-T10 | MAXIMIC | Microprocessor reset circuit. Reset threshold 3.08V. Push-pull active-high reset. 10k increments. |
| MAX759EPD | MAXIMIC | Adjustable, inverting carrent-mode PWM regulator. |
| MAX6321HPUK46AX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.630V, reset timeout(min) 1ms, watchdog timeout(typ) 102ms |
| MAX414MJD | MAXIMIC | Quad, 28MHz, low-noise, low-voltage, precision op amp. |
| MAX6314US35D4-T | MAXIMIC | 68H11/bidirectional-compatible microprocessor reset circuit. Reset threshold(nom) 3.50V. Reset timeout period(min) 1120ms. |
| MAX6320PUK28DY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 1.12sec, watchdog timeout(typ) 1.6sec |
| MAX392MJE | MAXIMIC | Precision, quad, SPST analog switch |
| MX7575JEWN | MAXIMIC | CMOS, microprocessor-compatible, fast conversion time 5 microsec, 8-bit ADC. INL +-1 LSB. |
| MAX6321HPUK39BY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.900V, reset timeout(min) 20ms, watchdog timeout(typ) 1.6sec |
| MAX802SEPA | MAXIMIC | 3.0V or 3.3V microprocessor supervisory circuit. Reset threshold 2.925V. Active-low reset. Watchdog input. Backup-battery switch. Power-fail threshold accuracy +-2%. Power-fail comparator. Reset window +-2% |
| MAX199BC/D | MAXIMIC | Multi-range (+-4V, +-2V, +4V, +2V), +5V supply, 12-bit DAS with 8+4 bus interface |
| MAX4266ESA | MAXIMIC | Single, ultra-low-distortion, single-supply, 350MHz op apm with enable. Min gain 2V/V, single-supply operation +4.5V to +8.0V |
| MAX4606EPE | MAXIMIC | Low on-resistance (5om max), quad, SPST, CMOS analog switches (two NO and two NC switches). |
| MAX266ACWI | MAXIMIC | Pin and resistor programmed universal active filter. Accyracy 1% |
| MAX6501CMP085-T | MAXIMIC | Low-cost, +2.7V to +5.5V micropower temperature switch. Output stage open-drain. Standard temperature threshold(C) +85. |
| ICL7611DCTV | MAXIMIC | Single operational amplifier, 15mV |
| MAX6316LUK43DZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.300V, min reset timeout 1120ms, typ watchdog timeout 25.6sec |
| MAX4052ESE | MAXIMIC | Low-voltage, CMOS analog multiplexer |
| MAX703CPA | MAXIMIC | Low-cost microprocessor supervisory circuit with battery backup. Precison supply-voltage monitor 4.65V. |
| MAX6317HUK38AX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.800V, min reset timeout 1ms, typ watchdog timeout 102ms |
| MAX6317HUK33AX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.300V, min reset timeout 1ms, typ watchdog timeout 102ms |
| MAX767RCAP | MAXIMIC | 5V-to-3.3V, Synchronous, step-down power-supply controller. Ref.tol.+-1.8%, Vout 3.45V |
